Handwelded - Handmade freestanding cake hoop stand - 80cm mild steel 10mm hoop with the space size of 68cm.
The support plates are 30cm and has a support bar of 10cm perfect ideally for adding decorations below the cake.
The stand can take the weight of any 4 tier cake but needs to be used on a flat surface and floral placement should be distributed according to the balance of the stand.
IMPORTANT INFROMATION - PLEASE NOTE -
The support plate and the cake plate are both screw plated for easy storage and transportation.To set up your stand, please ensure you place the base plate on a low level flat surface so that you can screw the hoop into place from above and ensuring it stays level, do not over turn on an angle as this will affect the thread and prevent the plate from sitting level. Add the top plate in the same way.
Total stand weight is approximately 4kgs.
This stand is NOT powder coated - and will require re-spraying over use. It also enabl you to re-spray the stand in an alternative finish should you wish.
There’s a choice of metallic finishes Gold, Silver, rose gold and Copper - see RUSTOLEUM spray paint for the colours of metallics used. Plus matt finishes of white & black.
Decoration not included - suitable for DIY use. Metal care - Please be aware that the metal may tarnish or could chip with use (especially if used at Weddings every week) and the metal is made from welded steel and if left out in changing weather conditions or is exposed to water the steel will rust over time - HOWEVER the metal can sprayed with rustoleum spray (available in all the metallic colours used) so if you lightly sand the metal you are able to re-spray the metal again - a new coat of rustoleum will bring them back to life and you can continue to use the metal for a number of years.
Everything we make in metal is handmade and there will be a welded joint and some inperfections. We strive to make as many lovely accessories and props as possible and we hope you are satisfied with the product. Thank you.